Playhouse Design / May 13, 2018 / Ambra Marquis
After that its a matter of simply attaching the 2x6s together with galvanized nails. Ill want a smooth surface on the playhouse floor for my kids to walk on so that means laying down some plywood on the 2x6 floor joists. A couple 4x8 sheets of outdoor plywood should do the trick. Building the Playhouse Walls Building walls for a playhouse is pretty much the same method carpenters use to build a house. Using simple 2x4 studs Ill lay the boards out on the ground and create each wall as a separate unit. Then with some help from a friend Ill raise the completed walls vertically and nail the corners together... just like people used to do when building barns.
It is laid under the shingles and acts as a moisture barrier. The tenth and last step to build a playhouse is to install windows doors siding and trim paint and caulk everything as per playhouse plans. It is possible your playhouse plans will call for a dormer or two to fancy it up a bit. Those are easy and your playhouse plans will direct you how to install them. One last piece of advice for window installation is to use some type of safety glass to protect the children for when it breaks during play.
The good news about making a gabled roof is that you can buy some pretty inexpensive hardware that will essentially line up the roof rafters where you need them to go. Galvanized joist hangers will solve a lot of my problems here when it comes to hanging the rafters. There are plenty of instructions around for learning how to build a roof - for any kind of house not just playhouses. So with the pre-made joist hangers and a few instructions I think Ill be able to figure out this part of the project without too much trouble.