Indoor Playhouse / May 24, 2018 / Henriette Veilleux
The sixth step to build a playhouse is to sheath the walls with plywood or oriented strand board (OSB). The easiest way to do this is to attach the plywood while the walls are laying down on the subfloor. However it is critical you square the walls before applying and attaching the plywood. If you use cedar plywood it will need stain to protect it if you choose not to cover it with an exterior siding. Continue by standing the walls up on the subfloor and attach the walls together. Dont forget to attach a top plate to the top of the walls...this gives it strength to hold up the roof. Repeat for inside walls.
The plans may also call for a front porch or back deck depending on the playhouse plans. Your playhouse plans should give direction on how to complete this task. The fifth step to build a playhouse is framing the exterior walls which is very similar to framing the walls of a house except on a smaller scale. Here you have to lay out the walls on the subfloor. You will measure mark and cut top and bottom plates. Dont forget the window placement as you create the walls. Cut various headers king studs cripple studs and sills.
The good news about making a gabled roof is that you can buy some pretty inexpensive hardware that will essentially line up the roof rafters where you need them to go. Galvanized joist hangers will solve a lot of my problems here when it comes to hanging the rafters. There are plenty of instructions around for learning how to build a roof - for any kind of house not just playhouses. So with the pre-made joist hangers and a few instructions I think Ill be able to figure out this part of the project without too much trouble.