Indoor Playhouse / May 20, 2018 / Ambra Marquis
Decking and Sheathing Next comes the most rewarding part of the project: adding plywood panels to the roof (decking) and the walls (sheathing). For roof decking most playhouse plans call for 1/2" plywood panels that Ill simply nail down on to the rafters. Getting at the panels to nail them down might be a little tricky though. Some people suggest you go at them from inside the playhouse - with a step ladder poking up between the rafters. Then after each panel goes down Ill come down move my ladder and go back up for the next section.
The good news about making a gabled roof is that you can buy some pretty inexpensive hardware that will essentially line up the roof rafters where you need them to go. Galvanized joist hangers will solve a lot of my problems here when it comes to hanging the rafters. There are plenty of instructions around for learning how to build a roof - for any kind of house not just playhouses. So with the pre-made joist hangers and a few instructions I think Ill be able to figure out this part of the project without too much trouble.
After that its a matter of simply attaching the 2x6s together with galvanized nails. Ill want a smooth surface on the playhouse floor for my kids to walk on so that means laying down some plywood on the 2x6 floor joists. A couple 4x8 sheets of outdoor plywood should do the trick. Building the Playhouse Walls Building walls for a playhouse is pretty much the same method carpenters use to build a house. Using simple 2x4 studs Ill lay the boards out on the ground and create each wall as a separate unit. Then with some help from a friend Ill raise the completed walls vertically and nail the corners together... just like people used to do when building barns.